FlexLab™ X Total Lab Automation Manually Remove Sample Tubes From the Automation System Job Aid

FlexLab TM X Total Lab Automation SIEMENS Healthineers Manually Remove Sample Tubes From the Automation System Job Aid Manually Remove Sample Tubes From the Automation System Sample tubes can be manually removed from the Automation System in the event that all the following conditions occur at the same time: • Unexpected lack of incoming power • Unexpected lack of air supply • The Automation System power supply is going to be Off for a long period which could cause possible damage to samples Template Effective Date: 10 Aug 2021 | HILS 2223 1 Effective Date: 28 Mar 2024 | QR700002750 Unrestricted I Published by Siemens Healthineers AG | © Siemens Healthineers AG, 2024 FlexLab TM X Total Lab Automation SIEMENS Healthineers Manually Remove Sample Tubes From the Automation System Job Aid 3 Manually Remove Sample Tubes From the Automation System, continued 1. Ensure the power supply to the Automation System is switched off 2. Set all connected Analyzers to non-operational mode 3. Open the security covers of the Automation Modules and the connected Analyzers Interface Modules 4. Manually remove all accessible sample tubes 5. Close all security covers 6. If samples are inaccessible, contact Siemens Service Support to ...... remove upper covers over the track in order to reach remaining sample tubes 7. Restore all covers 2 Effective Date: 28 Mar 2024 | QR700002750 Unrestricted I Published by Siemens Healthineers AG | © Siemens Healthineers AG, 2024 SIEMENS Healthineers Please note this learning material is for training purposes only. FlexLab TM X Automation is manufactured by Inpeco and distributed by Siemens Healthcare Diagnostics Inc. FlexLab is a trademark of Inpeco SA. For the proper use of the software or hardware, please always use the Operator Manual or Instructions for Use (hereinafter collectively “Operator Manual”) issued by Siemens Healthineers. This material is to be used as training material only and shall by no means substitute the Operator Manual. Any material used in this training will not be updated on a regular basis and does not necessarily reflect the latest version of the software and hardware available at the time of the training. The Operator Manual shall be used as your main reference, in particular for relevant safety information like warnings and cautions. Please note: Some functions shown in this material are optional and might not be part of your system. Certain products, product related claims or functionalities (hereinafter collectively “Functionality”) may not (yet) be commercially available in your country. Due to regulatory requirements, the future availability of said Functionalities in any specific country is not guaranteed. Please contact your local Siemens Healthineers sales representative for the most current information. The reproduction, transmission or distribution of this training or its contents is not permitted without express written authority. Offenders will be liable for damages. All names and data of patients, parameters and configuration dependent designations are fictional and examples only. All rights, including rights created by patent grant or registration of a utility model or design, are reserved. Siemens Healthineers HQ I Siemens Healthineers AG Siemensstr. 3 91301 Forchheim Germany Phone: +49 9191 18-0 siemens-healthineers.com 3 Effective Date: 28 Mar 2024 | QR700002750 Unrestricted I Published by Siemens Healthineers AG | © Siemens Healthineers AG, 2024