Eco-Power mode video

Ecopower mode EPM is a technology that saves energy by optimizing the cooling performance when the system is not in use in Mr Image Ng. It's important to keep the superconducting magnet of the scanner at specific low temperatures to avoid overheating in normal scanners. A lot of energy is consumed to keep the magnet continuously cooled whether the system is in operation or not. In this process, liquid helium is used as a cooling agent during imaging. The magnet warms up there by it also warms up the cooling agent and the liquid helium turns into helium gas as scanner component called the cold head is used to cool down the helium gas into its liquid form. Again, this is known as Zero boiloff technology. This cooling process goes on nonstop 24/7 even when the Mr Scanner is not in operation. Ecopower introduces on off cooling cycles to cool the magnet when the scanner is not used, and this is how it works. Ego Power is a standard feature in MRI scanners from Siemens Healthineers that allows energy saving. It is generally enabled at installation and automatically activated once the scanner. Is in standby or switched off. When Echo Power is on, the helium is not cooled continuously but in on off cooling cycles. Within one cycle, the cold head switches on and off following certain rules. When the cold head is off, the typical noise of the cold head also stops. The magnet and cooling parameters like pressure and temperature are continuously monitored independent from the status of the cooling cycle. The length of a cycle depends on specific parameters, which can be magnet pressure, thresholds or time depending on the scanner. When you turn the scanner back on again, Ecopower is immediately switched off and the system is ready to scan without delay. Compared to continuous energy consumption, the E PM allows up to 30% savings in energy. That's why it's called ego power.

Please note that the learning material is for training purposes only! zzzz For the proper use of the software or hardware, please always use the Operator Manual or Instructions for Use (hereinafter collectively "Operator Manual") issued by Siemens Healthineers. This material is to be Eco-Power introduces Eco-Power used as training material only and shall by no means substitute the Operator Manual. Any material used Eco-Power mode SIEMENS in this training will not be updated on a regular basis and does not necessarily reflect the Latest version of the software and hardware available at the time of the training. on/off cooling cycles The reproduction, transmission or distribution of this training or its contents is not permitted without express written authority. Offenders will be liable for damages. cools the magnet and The Operator Manual shall be used as your main reference, in particular for relevant safety information Healthineers optimizes cooling performance when CH like warnings and cautions. to cool the magnet when All names and data of patients, parameters and configuration dependent designations are fictional System off the system is not in use with saves energy when the and examples only. Note: Some functions shown in this material are optional and might not be part of your system. the scanner is not used. Certain products, product related claims or functionalities described in the material (hereinafter collectively AIL rights, including rights created by patent grant or registration of a utility model or design, are Eco-Power "Functionality") may not (yet) be commercially available in your country. Due to regulatory requirements, reserved. the future availability of said Functionalities in any specific country is not guaranteed. Please contact your EPM on EPM off local Siemens Healthineers sales representative for the most current information. Copyright O Siemens Healthcare GmbH, 2020 Conventional Eco-Power non-stop cooling cooling cycles